Tuesday, November 11, 2014

3D printed radio installation

Today, I could see a very nice radio installation in a Electro Alpina 4001. All the different part have been 3D printed. The servo tray use an inner honeycomb structure. the propulsion battery support can move to change the center of gravity. The orange box host the receiver and the power switch. I have no picture, but the servos covers were also 3D printed. All parts uses PLA material and are made on a printer having a volume of 20cm x 20cm by 15cm for the height. The result is very neat and clean as you can see on the pictures.


No comments:

Post a Comment

Mistral Soaring - Rognac

Yesterday we had a good friendly winter contest in Rognac, between Aix en Provence and Marseille. I left Grenoble aroudn 7am under the sn...